Autodesk Simulation Moldflow Adviser
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
Design Link cannot open SolidWorks 2009
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
180 Views, 1 Replies
03-31-2009 02:14 PM
Just installed Moldflow Advisor 2010 and DesignLink 2010.
DesignLink 2010 will not open a SolidWorks 2009 file. I had no problems with the identical part saved as SolidWorks 2006. But even the most simple 2009 part makes DesignLink barf.
Is this expected? Is there a forthcoming version of DesignLink that will work?
DesignLink 2010 will not open a SolidWorks 2009 file. I had no problems with the identical part saved as SolidWorks 2006. But even the most simple 2009 part makes DesignLink barf.
Is this expected? Is there a forthcoming version of DesignLink that will work?
Re: Design Link cannot open SolidWorks 2009
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
04-02-2009 10:18 AM in reply to:
BillEaton5991
Hi Bill,
This is expected because Autodesk Mldflow Design Link 2010 does not yet support SolidWorks 2009.
Until this version is supported, please export your model in Parasolid format. You can then import the Parasolid model into Autodesk Moldflow Adviser 2010.
Thanks,
Murali Annareddy
Product Manager
Autodesk Inc.
This is expected because Autodesk Mldflow Design Link 2010 does not yet support SolidWorks 2009.
Until this version is supported, please export your model in Parasolid format. You can then import the Parasolid model into Autodesk Moldflow Adviser 2010.
Thanks,
Murali Annareddy
Product Manager
Autodesk Inc.
