Autodesk Simulation Moldflow Insight

[#1]

Hi all, I hope you could help me with this issue:

I've been working with the Moldflow-ANSYS interface and I've found some difficulties. When I open the Moldflow exported file in ANSYS I observe some stresses in the part that match those observed in Moldflow under the name: Von Mises (warp). I've been looking through Moldflow's help for this kind of stress and I've found nothing. 

Should I take this Von Mises (warp) as a residual stress of the injected part? if that's the case, do this Von Mises (warp) occur during the injection process or after it?

[#2]

Hi all, I hope you could help me with this issue:

I've been working with the Moldflow-ANSYS interface and I've found some difficulties. When I open the Moldflow exported file in ANSYS I observe some stresses in the part that match those observed in Moldflow under the name: Von Mises (warp). I've been looking through Moldflow's help for this kind of stress and I've found nothing. 

Should I take this Von Mises (warp) as a residual stress of the injected part? if that's the case, do this Von Mises (warp) occur during the injection process or after it?