Autodesk Simulation CFD

[#1]

labyrinth packing
At the entrance of 1000 Pa. medium air
The rotation of the shaft 10 000 rev / min.
The clearance between the shaft and the labyrinth 0.15 mm

Determine the leakage of air through the maze.
Placed at the output of 0 Pa.
In solving are too little speed honey shaft and labyrinth.
Help

[#2]

Hi, 

Please could you be a little more specific about the problem? I understand that you have 1000pa on one side and 0 on the other, the unit is rotating and you have a small clearance.

Do you have a very good mesh through that small gap?

What do you mean by 'In solving are too little speed honey shaft and labyrinth' ?

[#3]

The situation is this.
For large shaft speed of the maze thrown oil.
Necessary to analyze and optimize the design of seals labirintnogno

[#4]

OK, those help. What about the mesh on the cut-plane? You need a good 4-5 elements though each of those gaps ideally.

What is your actual question, are the results not what you are expecting to see?