Autodesk Robot Structural Analysis

[#1]

Hi,

I have problem modelling a moving load, im doing a arbitrary vehicle, when I asign a value for FZ its later reduced when I look in the geometry section. I wonder if there is a factor somewhere reducing this value. I would like to use the asigned FZ-value for my calculations , not the reduced one.

Regards,

Anders

[#2]

Only if you define some reduction coefficients in the parameters of the route. Reading your question I don't think you defined them. Most likely the load has not been applied in full - I need the file to tell more. Please indicate which vehicle position to look at.

[#3]

Attached is the model, the vehicle load is case 72: Travers 

[#4]

Load direction should be vertical.

If you find your post answered press the Accept as Solution button please. This will help other users to find solutions much faster. Thank you.