Autodesk Revit MEP

[#1]

Thank you for the journal file.

The first thing I see is that Update 2 is not installed. I would download and install Update 2 from the page below:

Revit MEP: http://usa.autodesk.com/adsk/servlet/item?siteID=123112&id=14973660

Having said that, the issue is that the type definition of a shared parameter "Phase" does not match between the project file and family. I would verify the type definitions are the same.

[#2]

By phase do you mean, and electrical phase? Robert Schnure Mechanical Designer/Cad Coordinator Mechanical Engineering Tel.: (610) 524-5920 x 2251 Dir.: (610) 423-6251 Toll free: (877) 243-9711 Fax: (610) 524-2443 SNC-Lavalin Project Services, Inc. 436 Creamery Way, Suite 100 Exton | Pennsylvania | United States | 19341NOTICE - This email message, and any attachments, may contain information or material that is confidential, privileged and/or subject to copyright or other rights. Any unauthorized viewing, disclosure, retransmission, dissemination or other use of or reliance on this message, or anything contained therein, is strictly prohibited and may be unlawful. If you believe you may have received this message in error, kindly inform the sender by return email and delete this message from your system. Thank you.

[#3]

That does look like the parameter Revit is having the issue with.

[#4]

I am having a similar if not identical issue.  Did you figure out a way to resolve this?

-J

[#5]

To confirm if this is the same issue, please upload a journal from the session where you are seeing the behavior.

[#6]

Here you are sir.  Hope this helps.

[#7]

Thank you for the update.

From the journal file, it does look to be the same issue. You'll need to delete the shared parameter from the family, and recreate it both the family and project file.

Having said that, if you are on Subscription, we may have additonal options.

[#8]

I have tried to delete the parameter from the family, but I still get the same outcome when I try to load it.  According to the journal file, it is still hanging up on the "phase" parameter even though I deleted it.  Is there a way to remove a shared parameter from a family other than from the "family types" dialogue?

[#9]

I believe I am having the same issue with a mismatched shared parameter "phase".  I have attached my journal file, has there been a resolution to this?  I've tried to remove all the parameters, but still seem to have the problem.

I also have a subscription, you mentioned there may be other options?