Autodesk Revit MEP Wishes

[#1]

i would like to see the flexibility of turning off homerun arrows in a circuit run that when creating a circuit of a number of devices they dont show up until you get to the homerun itself. or give us the flexiblity to size and move the homeruns along a circuit so that they dont look a bit "special" when it bumps a device

[#2]

Absolutely necessary, the arrowheads showing up on downstream device circuits obliterate the device they are connected to.

[#3]

Got my vote!!!!!!

Is it really a "home run" from one light fixture to the next? (I don't think so!)

[#4]

It is very odd that by this time with so many engineers having the same concern that a fix has not been created.  There is no designer anywhere that would consider this graphic flaw in circuiting acceptable.  Please Autodesk if you have any concern on the correct graphic output of the Revit Electrical system fix this as soon as possible.

[#5]

I may be new to Revit MEP but the inital post was on: 07-30-2008 02:51 PM. The last post on this discussion group was on 07-11-2012 11:15 AM.

Out of sheer curiosity, does Autodesk - who as an unbelievable source of manpower - cannot (for the life of me) resolve this or be willing to even listen to this minimal request after 4+ years?

Is it maybe because only four interested, 5 now including me, have made comments? Makes me wonder how much more till a wish is finally granted...

By the way, been trying to figure this out and still to no avail on MEP 2013 - the arrows just doesn't look graphically right, yet it seems that Autodesk thinks its fine when it comes to circuiting! Quite ironic in a sense.

Here's to hoping

[#6]

even if we can turn it off on vv/vg settings it still doesn't work the way one would like it shown. more control would be better for sure.

[#7]

This absolutly needs to be fixed.  Working in the design build field with contractors, it gets brought up over and over again about how the homeruns look <insert word here>! Also, the multiple arrows at the end of the run in not necessary either, please make this a non-defaut option rather than the only option.