Autodesk Revit Architecture
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
Placing a void extrusion through a structural beam system (roof cladding)
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
311 Views, 2 Replies
05-25-2010 04:32 AM
I've made a corrugate roofing profile and then placed the profile in a beam system. All is going well until I get to the end of the roof where it has an angular cut rather than a 90° cut. I've tried placing a void extrusion through the overhanging roofing sheets but that hasn't appeared to have worked. Any suggestions would be greatly appreciated.
Re: Placing a void extrusion through a structural beam system (roof cladding)
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
05-25-2010 03:08 PM in reply to:
craigj000
Try this post:
http://discussion.autodesk.com/forums/thread.jspa?
bt
http://discussion.autodesk.com/forums/thread.jspa?
bt
Re: Placing a void extrusion through a structural beam system (roof cladding)
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
05-25-2010 03:33 PM in reply to:
craigj000
Awesome, cheers so much for that. What an interesting work around.
