Autodesk Revit Architecture

[#1]

In floor plan view how do I make a wall have a concrete texture inside instead of the default (criss cross)?

[#2]

Under Wall Properties, Edit>Structure>Materials--change to Concrete for the Cut Pattern.

The "criss-cross" pattern is typically for Concrete Masonry Units ( block), so you should really use a different Wall Type

and name it Cast In-Place Concrete, then specify the correct Material and Fill Pattern.

[#3]

Thank you. I have made a new wall how you said, changing the material to cast-in place concrete instead of concrete blocks and on the preview for the wall it is perfect but when I draw the line on the floor plan it still has a criss-cross pattern. I have attached a picture where you can see how the wall looks in the properties preview and on the floor plan it  is highlighted.

Thank you,

Yehuda

[#4]

In Wall Properties, check if there is a Coarse Scale Fill Pattern.

Then in your view, set the Detail Level to Medium or Fine.

Does it now have the Concrete Fill Pattern?

[#5]

I set the wall to no pattern and then to concrete pattern and they both still have the criss-cross. It seems like the criss-cross is a default and the only way to change it is to override each individual wall. Thank you, Yehuda Inbar, AIA *Inbar Architecture* * * **2831 Ringling Blvd., Suite E-117 Sarasota, FL 34237 (941) 951-2816 InbarArchitecture@gmail.com www.InbarArchitect.com

[#6]

Check if the Material is set to "Default Wall"

Go to Manage>Materials then look at Cut Pattern.

See if your wall's Material is really using Default Wall Material--or recheck the Coarse Fill setting under wall properties.

[#7]

I went into the materials and the cut pattern is set to concrete. I'm not sure how to check if it is set to default wall. I have attached an image with the walls I am trying to edit just left of the browser. Thank you, Yehuda Inbar, AIA *Inbar Architecture* * * **2831 Ringling Blvd., Suite E-117 Sarasota, FL 34237 (941) 951-2816 InbarArchitecture@gmail.com www.InbarArchitect.com

[#8]

Check these settings as well.

see attached.

[#9]

Hello everyone, I wanted to know how do I configure my Revit Architecture 2013 software so it can save files in previous versions (2012, 2011, 2010)
thank you

[#10]

Revit is not Backwards Compatable......................

Mike