Autodesk Quantity Takeoff
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
categorisi
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
402 Views, 0 Replies
12-30-2012 10:13 AM
Im using QTO with a model for automatic take off, and trying to find a way of differentiating between a flat plasterboard ceiling which should be meaured as an area, and a strip of plasterboard which should be measured as a liner measurement.
At the moment all i can seem to get is all platerboard ceiling as an area, so my question is can I get QTO to look at an item and if the width is less than a certain amount meaure it as a length, and if it is greater than this amount then measure it as an area? also is it possible to differentiate between vertical and horizontal items?
many thanks
