Autodesk Inventor

[#1]

Hello, I'm a MDT 6 user and I was just wondering if Inventor had means to perform tolerance analysis on an assembly. The MDT way to do this is very cumbersome so I was looking at new software but will use inventor if it can do the job.

[#2]

If you mean setting dimensions at maximum or minimum tolerance, IV can do
it.

Rui


"jstraitiff" wrote in message
news:f19c292.-1@WebX.maYIadrTaRb...
> Hello, I'm a MDT 6 user and I was just wondering if Inventor had means to
perform tolerance analysis on an assembly. The MDT way to do this is very
cumbersome so I was looking at new software but will use inventor if it can
do the job.
>

[#3]

Is there any ability to do a tolerance analysis with GD&T?

[#4]

Not that I know of. That would be a pretty cool and useful feature to have.

You  can set tolerances to min/max/median/nominal and then check for interferance in the assembly environment.