Autodesk Inventor
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
*Gately, Jeff
theoretica
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
38 Views, 1 Replies
12-09-2002 06:33 AM
I need to dimension to a theoretical intersection with in an Inv R6 idw
file. Is there a way to dimension to such a point?
Jeff Gately
file. Is there a way to dimension to such a point?
Jeff Gately
*Keller, Kent
Re: theoretica
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
12-09-2002 06:35 AM in reply to:
*Gately, Jeff
start the dimension, select one edge, then rmb and select intersection, then hover over
the other edge. when you see a yellow dot in the intersection click.
--
Kent
Member of the Autodesk Discussion Forum Moderator Program
"Jeff Gately" wrote in message
news:C13680E1905CD6161CEA792F98B18607@in.WebX.maYI
> I need to dimension to a theoretical intersection with in an Inv R6 idw
> file. Is there a way to dimension to such a point?
>
>
> Jeff Gately
>
>
the other edge. when you see a yellow dot in the intersection click.
--
Kent
Member of the Autodesk Discussion Forum Moderator Program
"Jeff Gately"
news:C13680E1905CD6161CEA792F98B18607@in.WebX.maYI
> I need to dimension to a theoretical intersection with in an Inv R6 idw
> file. Is there a way to dimension to such a point?
>
>
> Jeff Gately
>
>
