Autodesk Inventor
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
iMates & invisibili
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
36 Views, 1 Replies
11-29-2002 06:51 PM
Hello, All.
I have a little question about iMates.
Can i hide iMates signs in Inventor's 5.3 assembly file?
Is it possible or not?
--
Best regards,
Dmitry mailto:kostikov@vstu.ru
I have a little question about iMates.
Can i hide iMates signs in Inventor's 5.3 assembly file?
Is it possible or not?
--
Best regards,
Dmitry mailto:kostikov@vstu.ru
*Maas, Karl
Re: iMates & invisibili
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
12-01-2002 09:47 PM in reply to:
red1
they disappear when you use them to constrain to
your assembly. Other wise, I think you have to go into the original part and
turn off iMate glyphs in the View pull-down.
your assembly. Other wise, I think you have to go into the original part and
turn off iMate glyphs in the View pull-down.
--
K
style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">
"red1" <kostikov@vstu.ru>Hello,
wrote in message
href="news:f128679.-1@WebX.maYIadrTaRb">news:f128679.-1@WebX.maYIadrTaRb...
All.
I have a little question about iMates.
Can i hide iMates signs in
Inventor's 5.3 assembly file?
Is it possible or not?
--
Best regards,
Dmitry
mailto:kostikov@vstu.ru
