Greetings! I started to explore iFeatures not long ago, and now I encountered something I can't explain or find the way around. I defined my iFeature (a relief groove for the thread) to rest upon two circular edge projections. But when I try to place this iFeature on the part, I cannot pick the edges to serve as reference lines for my purpose, because Inventor simply does not allow that. I can olny pick faces, which give me completely wrong reference lines. What the matter? I can can pick only the edge when I'm not placing iFeature, but in iFeature mode it is prohibited? Am I doing something wrong? Please advice!
Can you post your Inventor version and the original part the iFeature was based upon?
Please mark this response as "Accept as Solution" if it answers your question. ____________________________________________________________ Dennis Jeffrey, Author and Manufacturing Trainer, Autodesk Inventor Certified Expert Autodesk Manufacturing Implementation Certified Expert Autodesk Silver Manufacturing Partner
