Autodesk Inventor
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
hole at an angle?
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
64 Views, 2 Replies
12-04-2002 10:22 PM
i want to make a hole (drill and tap) at 10 degree angle on a surface. it is possible something like that and how?
thanks,
picozon
thanks,
picozon
*Keller, Kent
Re: hole at an angle?
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
12-04-2002 11:04 PM in reply to:
picozon
you need to set up a angled workplane. If you don't have all the geometry
you need to make the workplane, you need to use other workfeatures such as
points and axis. Don't forget you can use the origin planes when creating
new planes also.
--
Kent Keller
Member of the Autodesk Discussion Forum Moderator Program
http://www.MyMcad.com/KWiK/Mcad.htm
"picozon" wrote in message
news:f129c28.-1@WebX.maYIadrTaRb...
> want to make a hole (drill and tap) at 10 degree angle on a surface. it is
possible something like that and how? thanks,
> picozon
you need to make the workplane, you need to use other workfeatures such as
points and axis. Don't forget you can use the origin planes when creating
new planes also.
--
Kent Keller
Member of the Autodesk Discussion Forum Moderator Program
http://www.MyMcad.com/KWiK/Mcad.htm
"picozon"
news:f129c28.-1@WebX.maYIadrTaRb...
> want to make a hole (drill and tap) at 10 degree angle on a surface. it is
possible something like that and how? thanks,
> picozon
*Berry, Patrick
Re: hole at an angle?
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
12-04-2002 11:05 PM in reply to:
picozon
Sure, make a workplane at 10deg through where you
want to have the hole intersect the plane (you may have to create some other
work geometry first), put a sketch on that plane and then create the
hole.
want to have the hole intersect the plane (you may have to create some other
work geometry first), put a sketch on that plane and then create the
hole.
Pat
style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">
"picozon" <want
href="mailto:cicipicozon@yahoo.com">cicipicozon@yahoo.com> wrote in
message
href="news:f129c28.-1@WebX.maYIadrTaRb">news:f129c28.-1@WebX.maYIadrTaRb...
to make a hole (drill and tap) at 10 degree angle on a surface. it is possible
something like that and how? thanks,
picozon
