You will probably have to do a Split-Face on the riser pipe. This will give a funny result at the points on the riser pipe.
Your Split-Face line will start at the end-point of the cope of the Riser pipe.
IV2014.1 PDSU / Sim Mech 2014 /
EVGA X79 - Classified, iCore7 3930k 32Gb Quad-Channel
950Gb (2 x 500Gb Sata III SSD RAID0 Adaptec 6805E Controller)
Nvidia GTX-690 Classified - 314.07
SpacePilot Pro 3.16.1 / 6.16.0 / 4.11
Did you ever figure this out?
I am dealing with exactly the same problem, putting weldments on two pipes of same diameter. I tried to use Split-Face but couln't get this to work. Help would be very much appreciated.