Autodesk Inventor
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
*Johnson, Bob
Tool Icons
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
21 Views, 0 Replies
11-21-2002 11:55 AM
Can Tool Icons be placed on more than one Toolbar at the same time? So that
I can select then from more that one Toolbar?
Also, went to the Inventor Glossary to check Inventors definition of a line.
Line, Geometry consisting of a straight curve bounded by two endpoints.
There was other wording there, but it went on to over define (IMHO) the
word, Line or did I miss something? TIA, Bob
I can select then from more that one Toolbar?
Also, went to the Inventor Glossary to check Inventors definition of a line.
Line, Geometry consisting of a straight curve bounded by two endpoints.
There was other wording there, but it went on to over define (IMHO) the
word, Line or did I miss something? TIA, Bob
