Autodesk Inventor
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
Thread feature not displayed in hole table
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
73 Views, 1 Replies
11-29-2012 04:49 AM
Hello,
Yesterday I tried to make a table-driven I-feature of a few drilling paterns.
I want to use this for drawing steel manifolds. The I-feature is used to insert standard drilling paterns, for example a patern to fit a standard flange.
The only problem is, for the thread I used the thread feature, otherwise it doesn't show up in the I-feature.
But when I make a drawing of a part were this I-feature is used, the specification of the thread doesn't show up when I create a hole table, because in the I-feature, the thread is a separate feature.
Does anybody know a fix for this problem.
Re: Thread feature not displayed in hole table
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
12-03-2012 03:16 AM in reply to:
hydrallhydraulic
Hello,
just use Hole feature to create threaded hole. iFeature can use them as well (including thread properties).
Regards,
Jozef
