Autodesk Inventor
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
*Keller, Kent
Sometimes you feel like a nut..... sometimes you are! 8^)
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
32 Views, 0 Replies
10-31-2002 02:05 PM
Do'h
I just found that I had zipped up the wrong version of Copy N Set material
macro on my site. If you downloaded it previously I apologize, but please
to be safe delete it and get the version that is there now. Sorry for any
inconvenience. The version now should match the picture a little closer
Also I have updated the Insert and Fix macro to allow a larger selection set
of files. It still has a limit of # of files that can be selected, but that
limit is now quite a bit higher.
--
Kent Keller
Member of the Autodesk Discussion Forum Moderator Program
http://www.MyMcad.com/KWiK/Mcad.htm
I just found that I had zipped up the wrong version of Copy N Set material
macro on my site. If you downloaded it previously I apologize, but please
to be safe delete it and get the version that is there now. Sorry for any
inconvenience. The version now should match the picture a little closer
Also I have updated the Insert and Fix macro to allow a larger selection set
of files. It still has a limit of # of files that can be selected, but that
limit is now quite a bit higher.
--
Kent Keller
Member of the Autodesk Discussion Forum Moderator Program
http://www.MyMcad.com/KWiK/Mcad.htm
