Autodesk Inventor

[#1]

Hi All,

I have asked this question before on several forums without any resolution.  I have just purchased a new computer running Windows 7.  My Inventor is 2011 Professional - Student.  Now without anything else installed I installed my Inventor program, so everthing is clean and Inventor cannot be interferred with by anything else.

Yet I still cannot save/export a drawing to Autocad dwg of dxf.  Why!!  Both programs are from the same stable - Autodesk.  Catia is there along with Parasolid, Pro/Engineer etc.  Surely there is something that either I'm not doing right or the program is faulty.

WHAT PRAY IS THE ANSWER!!

Dave R

[#2]

i do not believe the student version will allow you to do this. if it were to allow you, then you could remove the plot stamp about educational version blah blah... sorry

[#3]

---

rbarnhill8138 wrote:

i do not believe the student version will allow you to do this....

---

There is no difference in functionality between the commercial license and the student license.
I have run student license (as an instructor) for years and can save as dwg  or dxf just fine.

Was Inventor installed with UAC and anti-virus off?
Have you installed all Service Packs?
Where is your instructor, it would be far easier to diagnose this problem sitting at the keyboard.

[#4]

Hi There,

YES, I made doublely sure that UAC was turned off and being a new computer I have not put any Anti-Virus programs on yet.  One thing I did notice when installing Inventor was a tick box that basically sain to install Inventor in default mode of with Autocad settings, or some such wording.  I opted for default mode thinking that this is only for the menu bars - Right or Wrong?

Best Rgds,

Dave R