Autodesk Inventor

[#1]

Attached is a bottom fixture block that I am having machined. It consists of 4 threaded through holes with two being drilled perpendicular to the top surface, and the other two holes are at 15 degree angles. There are two 7/8"-9 threaded holes and two 5/8"-11 threaded holes. Our drafter is out on vacation and I need to have a drawing of this produced by today. If anyone could help or at least point me in the right direction that would be great!

[#2 · Accepted solution]

Here is a start to a drawing for you.

Hope it gets you to where you need to be.

[#3]

Is anyone else upset, that rather than hire enough drafters, companies are moving towards panhandling for drawings on Autodesk forums?

...I'm half joking... but half not joking.

[#4]

I was going to mention that I get $45 an hour in the evenings for this. And yes I have the same problem, I need 2 more people here to catch up in moving to vault and I'm not able to hire them.

I would be willing to help like this some since I have had many people take time to teach me how to opperate the program when many here are paid to teach. So I guess it all depends on your perspective.

(wow, the model I started opening when I started this thread just opened. back to work)