Autodesk Inventor
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
Properties
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
39 Views, 3 Replies
11-25-2002 10:30 PM
I'm trying to automate the file translation from IV to ACAD.
I have read that there are routines somewhere to do this but can't find any.
Where are they?
Also, can you export the properties from IV to a file that can be used for attributes in ACAD?
Thanks,
jerome.kunert@airgage.spx.com
I have read that there are routines somewhere to do this but can't find any.
Where are they?
Also, can you export the properties from IV to a file that can be used for attributes in ACAD?
Thanks,
jerome.kunert@airgage.spx.com
*Hinterhoeller, Richard
Re: Properties
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
11-25-2002 11:16 PM in reply to:
jeromekunert
Look at:
http://www.mymcad.com/
Under Inventor >> Nifty Routines
Lots of gems at this site and others mentioned in the weekly ***
INVENTOR FAQ... message
Richard
http://www.mymcad.com/
Under Inventor >> Nifty Routines
Lots of gems at this site and others mentioned in the weekly ***
INVENTOR FAQ... message
Richard
Re:
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
11-26-2002 04:16 AM in reply to:
jeromekunert
On mymcad site the one that looks like it would help,Inventor DWG Reformat takes me to a web sight that is password protected.
*Keller, Kent
Re:
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
11-26-2002 05:28 AM in reply to:
jeromekunert
From a earlier thread... go to "must have" section on Drew's site.
--
Kent
Member of the Autodesk Discussion Forum Moderator Program
"jeromekunert" wrote in message
news:f1276ff.1@WebX.maYIadrTaRb...
> On mymcad site the one that looks like it would help,Inventor DWG Reformat takes me to a
web sight that is password protected.
--
Kent
Member of the Autodesk Discussion Forum Moderator Program
"jeromekunert"
news:f1276ff.1@WebX.maYIadrTaRb...
> On mymcad site the one that looks like it would help,Inventor DWG Reformat takes me to a
web sight that is password protected.
