Autodesk Inventor
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
*Beissel, Josh
Placing Centerline on an arc
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
143 Views, 2 Replies
11-05-2002 10:33 PM
Is it Possible to place a centerline on a drawing that has an arc or radius?
(example: any dia. bar with a 90deg. bend or any deg. bend.) I want the CL
to follow the bend or arc that is placed not just straight lines horizontal
or vertical. I can get centerlines on my drawing as long as the lines I'm
working with are parallel or holes. I hope this is enough information.
Thanks Josh
(example: any dia. bar with a 90deg. bend or any deg. bend.) I want the CL
to follow the bend or arc that is placed not just straight lines horizontal
or vertical. I can get centerlines on my drawing as long as the lines I'm
working with are parallel or holes. I hope this is enough information.
Thanks Josh
Re: Placing Centerline on an arc
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
11-06-2002 12:07 AM in reply to:
*Beissel, Josh
If I understand correct. You have to do use a center line bisector pick the two arc lines
*Beissel, Josh
Re:
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
11-06-2002 12:24 AM in reply to:
*Beissel, Josh
Yes that worked. I used all of the tools
except that one when I was trying. thanks
except that one when I was trying. thanks
style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">
"jiml" <jiml@cadd.com> wrote inIf
message
href="news:f12052c.0@WebX.maYIadrTaRb">news:f12052c.0@WebX.maYIadrTaRb...
I understand correct. You have to do use a center line bisector pick the two
arc lines
