Autodesk Inventor
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
*Sam
Part vs sheetmetal
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
51 Views, 1 Replies
11-16-2002 11:52 PM
Is there anyway to convert a sheet metal part into a regular part?
Is there any difference except fot the menu it defaults to?
Is there any difference except fot the menu it defaults to?
*Keller, Kent
Re: Part vs sheetmetal
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
11-17-2002 12:17 AM in reply to:
*Sam
The biggest difference is the menus, and SM adds a few
parameters....Thickness act. To switch it just to etc. Applications
dropdown, and change it from Sheet Metal to Modeling.
--
Kent Keller
Member of the Autodesk Discussion Forum Moderator Program
http://www.MyMcad.com/KWiK/Mcad.htm
"Sam" wrote in message
news:F104AFC59EDDC932B7A8483105E8DF92@in.WebX.maYI
> Is there anyway to convert a sheet metal part into a regular part?
>
> Is there any difference except fot the menu it defaults to?
>
>
parameters....Thickness act. To switch it just to etc. Applications
dropdown, and change it from Sheet Metal to Modeling.
--
Kent Keller
Member of the Autodesk Discussion Forum Moderator Program
http://www.MyMcad.com/KWiK/Mcad.htm
"Sam"
news:F104AFC59EDDC932B7A8483105E8DF92@in.WebX.maYI
> Is there anyway to convert a sheet metal part into a regular part?
>
> Is there any difference except fot the menu it defaults to?
>
>
