• Industries
  • Products
  • Buy
  • Services & Support
  • Communities
    • Discussion Groups

    Autodesk Inventor

    Reply
    Topic Options
    Active Contributor cellt2
    Active Contributor
    cellt2
    Posts: 40
    Registered: ‎12-01-2010

    Importing Inventor Design Accelerator Components into Showcase

    Options
    97 Views, 1 Replies
    02-03-2013 08:56 PM

    Hi,

    I have a hybrid issue here. 

     

    When I import an Inventor model to Showcase, bolted connections are missing the bolt.  I get the washers and nuts but the bolt is gone.  I can overcome this by saving the bolt part in a project folder but this is time consuming. 

     

    Are there some settings I am missing or is it just another item to add to the fixit list?

    Report Inappropriate Content
    Message 1 of 2 (97 Views)
    Reply
    0 Kudos
    Please use plain text.
     
    *Expert Elite*
    *Expert Elite*
    blair
    Posts: 2,263
    Registered: ‎11-13-2006

    Re: Importing Inventor Design Accelerator Components into Showcase

    Options
    02-03-2013 11:48 PM in reply to: cellt2

    Make sure that you selected the correct Project file from Inventor that your IAM was created under. This will allow Showcase to find the directories for all the parts.

     

    Also make sure that you are current on all Showcase SP's. SP4 or even R1 (after SP4).

     

    Since you didn't post your version release I am assuming 2013

    Did you find this reply helpful ? If so please use the Accept as Solution or Kudos button below.

    IV2014.1 PDSU / Sim Mech 2014 /
    Win7-64
    EVGA X79 - Classified, iCore7 3930k 32Gb Quad-Channel
    950Gb (2 x 500Gb Sata III SSD RAID0 Adaptec 6805E Controller)
    Nvidia GTX-690 Classified - 314.07
    SpacePilot Pro 3.16.1 / 6.16.0 / 4.11
    Report Inappropriate Content
    Message 2 of 2 (88 Views)
    Reply
    0 Kudos
    Please use plain text.