Autodesk Inventor

[#1]

Hi, all

Im using frame generator, i create my skeleton part, start up frame generator, select my frame types and connect them to the lines, press OK, accept the default filenames then get this error:

[WARNING] Frame Generator: Errors occurred during inserting Frame Member(s)

    [WARNING] Insertion of frame member(s) failed

        [ERROR] A frame member could not be created.  The template file for ANSI ANSI AISC (Rectangular) - Flat Bar Steel could not be located in the Content Center library.

and no parts are put in the assembly.

I have updated the content centre etc and installed all the latest updates. I have also reinstalled Inventor and The local content centre but the error persists.

Ive included a couple of screen shots that show the error.

Please help as frame generator is useless until this is fixed and i need to design some frames.

Thanks for help in advance.

[#2]

Hi  cmharb,

You might want to check your project file and ensure that the Conent Center libraries are configured/included for it.

See the Configure Content Center Libraries topic listed under Procedures at this link:

http://wikihelp.autodesk.com/Inventor/enu/2013/Help/1310-Autodesk1310/1655-Assembli1655/1779-Content...

I hope this helps.
Best of luck to you in all of your Inventor pursuits,
Curtis
http://inventortrenches.blogspot.com

Here's an image of the Configure dialog I found in another thread, you should see the ISO library listed as shown:

[#3]

Yea they are all there.

The Bolt generator and Content Centre work fine, I can even insert Frame parts from the Content Centre but not using the Frame Generator

[#4]

can no one help me with this?

[#5]

Can you try a different CC library other than ISO

[#6]

yea, happens on all

[#7]

Can you check the ISO library properties and file size

[#8]

Can you get to this point?

[#9]

yup, have a look at the images i posted on my first post. It gets all the way through the wizard sequence and just when the part is supposed to appear i get the error message.

the content centure is on the vault, and doesnt show size etc.

[#10]

Probably a problem with your Vault settings then.