Autodesk Inventor
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
Frame Analysis on Merged bar
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
77 Views, 0 Replies
10-19-2012 07:36 PM
I sketched my car frame and dropped it into an assembly and used frame generator to create. The front and rear roll hoop are to be of one bar and the only way I've found to make it one bar is using the merge option in FG. Why is it when I run frame analysis, I cannot choose either of the merged bars to place nodes or force points on? Any help would be appreciated. I am running 2013 with sp1.
