Autodesk Inventor
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
*Wolfe
Fastener/L
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
43 Views, 1 Replies
11-29-2002 10:31 PM
Not sure how it was done, but can someone point me in the right
direction how to access Mounting hardware, Bearings etc. which
I think are loaded on a local CP.
Had a crash a while back and now a lot is screwed up.
Any help would be appreciated.
Wolfe
email: wolfed@sympatico.ca
direction how to access Mounting hardware, Bearings etc. which
I think are loaded on a local CP.
Had a crash a while back and now a lot is screwed up.
Any help would be appreciated.
Wolfe
email: wolfed@sympatico.ca
*Maas, Karl
Re: Fastener/L
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
12-01-2002 09:45 PM in reply to:
*Wolfe
www.cbliss.com
--
K
"Wolfe" wrote in message
news:17BC0BEA01998247E2C48CD83782EE74@in.WebX.maYI
> Not sure how it was done, but can someone point me in the right
> direction how to access Mounting hardware, Bearings etc. which
> I think are loaded on a local CP.
> Had a crash a while back and now a lot is screwed up.
>
> Any help would be appreciated.
>
> Wolfe
>
> email: wolfed@sympatico.ca
>
>
>
>
--
K
"Wolfe"
news:17BC0BEA01998247E2C48CD83782EE74@in.WebX.maYI
> Not sure how it was done, but can someone point me in the right
> direction how to access Mounting hardware, Bearings etc. which
> I think are loaded on a local CP.
> Had a crash a while back and now a lot is screwed up.
>
> Any help would be appreciated.
>
> Wolfe
>
> email: wolfed@sympatico.ca
>
>
>
>
