Autodesk Inventor
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
*Mark
Exporting Sheetmetal Flat Pattern
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
50 Views, 1 Replies
11-14-2002 05:57 AM
Hi
I have run into a glitch with version 6 of Inventor that I was not having
with version 5.3. When saving a sheetmetal flat pattern to a DXF file in
version 5.3 some curved lines were converted into splines and the put on the
correct layer. Now were they were splines before they are individual lines
with no layer assigned to them. My CNC program needs layers for it see the
line. So for now I have to open the file with Autocad and then put the
lines on the correct layer and resave. It is a real pain doing this. Is
there a solution for this?
Mark
I have run into a glitch with version 6 of Inventor that I was not having
with version 5.3. When saving a sheetmetal flat pattern to a DXF file in
version 5.3 some curved lines were converted into splines and the put on the
correct layer. Now were they were splines before they are individual lines
with no layer assigned to them. My CNC program needs layers for it see the
line. So for now I have to open the file with Autocad and then put the
lines on the correct layer and resave. It is a real pain doing this. Is
there a solution for this?
Mark
*Allen, Albert
Re: Exporting Sheetmetal Flat Pattern
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
11-14-2002 06:12 AM in reply to:
*Mark
go back to 5.3?
"Mark" wrote in message
news:975E3F140E5E57637C804034063D7250@in.WebX.maYI
> Hi
>
> I have run into a glitch with version 6 of Inventor that I was not having
> with version 5.3. When saving a sheetmetal flat pattern to a DXF file in
> version 5.3 some curved lines were converted into splines and the put on
the
> correct layer. Now were they were splines before they are individual
lines
> with no layer assigned to them. My CNC program needs layers for it see
the
> line. So for now I have to open the file with Autocad and then put the
> lines on the correct layer and resave. It is a real pain doing this. Is
> there a solution for this?
>
>
> Mark
>
>
"Mark" wrote in message
news:975E3F140E5E57637C804034063D7250@in.WebX.maYI
> Hi
>
> I have run into a glitch with version 6 of Inventor that I was not having
> with version 5.3. When saving a sheetmetal flat pattern to a DXF file in
> version 5.3 some curved lines were converted into splines and the put on
the
> correct layer. Now were they were splines before they are individual
lines
> with no layer assigned to them. My CNC program needs layers for it see
the
> line. So for now I have to open the file with Autocad and then put the
> lines on the correct layer and resave. It is a real pain doing this. Is
> there a solution for this?
>
>
> Mark
>
>
