The subject basically says it all. I am trying to emboss two words onto a solid model. Unfortunately it keeps failing. I am copying this model off of U-Tube models "LED LAMP"
Could anyone try and use the emboss feature for me and engrave the words "LED LAMP" On the centre of the top of my solid model part. Top View reads vertically going up the way.
I would be very grateful if someone would try and do it for me, save it and send it back or explain why it keeps failing.
Please edit part 8. Then start the Emboss process. 1/64 = Depth. Flat White colour. Following the video on youtube they use engrave from face then reverse the direction the arrow points towards the model. Then OK. That's the way I am showed it and I can't get it to engrave.
A CAD Student.
please e-mail any answers to here.
+44 1224 935375
Please engrave this because I cant do it and I dont understand WHY??
A CAD STUDENT.
What version of Inventor you on.?
Post just the part.
Please mark this response as "Accept as Solution" if it answers your question.
2012 Factory Design Suite ( will not load 2013)
What happen to my Inventor :-(
I am following the u-tube video. On the video The sketch is made on Work plane2. It is fully constrained on sketch 10. I am asking why wont it engrave from there it works on the video,
But thanks for your response.
I was hoping for an explanation why my model wont engrave and the video does??
A CAD Student.
Please do NOT double post! I just posted a reply to your other thread.