Autodesk Inventor
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
Elbow
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
52 Views, 1 Replies
11-11-2002 01:07 PM
I have been trying to figure out how to create an elbow with little luck. I am looking to make a 1/2" copper elbow. I can create the ends but I can't get the sweep. Any help would be appreciated. thanks.
*Keller, Kent
Re: Elbow
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
11-11-2002 02:15 PM in reply to:
np24
You might take a look at how some of the parts on this page were built
http://www.cbliss.com/inventor/Parts/Plumbing/plum
--
Kent Keller
Member of the Autodesk Discussion Forum Moderator Program
http://www.MyMcad.com/KWiK/Mcad.htm
"np24" wrote in message
news:f12236c.-1@WebX.maYIadrTaRb...
> I have been trying to figure out how to create an elbow with little luck.
I am looking to make a 1/2" copper elbow. I can create the ends but I can't
get the sweep. Any help would be appreciated. thanks.
http://www.cbliss.com/inventor/Parts/Plumbing/plum
--
Kent Keller
Member of the Autodesk Discussion Forum Moderator Program
http://www.MyMcad.com/KWiK/Mcad.htm
"np24"
news:f12236c.-1@WebX.maYIadrTaRb...
> I have been trying to figure out how to create an elbow with little luck.
I am looking to make a 1/2" copper elbow. I can create the ends but I can't
get the sweep. Any help would be appreciated. thanks.
