Autodesk Inventor
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
*Spires, Rick
Disappeari
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
26 Views, 0 Replies
11-21-2002 05:54 AM
There have been a few instances where I have run into .idw files of .iam
files and some of the part's lines disappeared in section views of round
assemblies. This was very inconsistent as in some of the section views,
there were no problems while in others, one half would be ok while the other
half would be missing some lines, but not the section lines - the section
lines were always visible. Specifically, all lines associated to a
particular part. The missing lines from view to view (if there is a problem
with more than one anyway) are not always the same part.
files and some of the part's lines disappeared in section views of round
assemblies. This was very inconsistent as in some of the section views,
there were no problems while in others, one half would be ok while the other
half would be missing some lines, but not the section lines - the section
lines were always visible. Specifically, all lines associated to a
particular part. The missing lines from view to view (if there is a problem
with more than one anyway) are not always the same part.
