Autodesk Inventor
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
*Joanne
Cross-bend
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
180 Views, 1 Replies
11-05-2002 06:18 PM
Is it possible to make a cross-bend on a plate ex. 2 x 1.5 deg?
J
J
*Keller, Kent
Re: Cross-bend
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
11-06-2002 12:57 AM in reply to:
*Joanne
There have been at least one method posted to customer files in the past. If I remember
right it was done with a shell and a face split but not positive.
Have you tired doing some searching in the old Newsgroup?
--
Kent
Member of the Autodesk Discussion Forum Moderator Program
"Joanne" wrote in message news:f1203d3.-1@WebX.maYIadrTaRb...
>
> Is it possible to make a cross-bend on a plate ex. 2 x 1.5 deg?
>
> J
>
>
right it was done with a shell and a face split but not positive.
Have you tired doing some searching in the old Newsgroup?
--
Kent
Member of the Autodesk Discussion Forum Moderator Program
"Joanne"
>
> Is it possible to make a cross-bend on a plate ex. 2 x 1.5 deg?
>
> J
>
>
