Autodesk Inventor

[#1]

I imported some dwg blocks into Inventor with the
idea that I use them in conjunction with other parts in an
assembly.

Having done so, I can't hide the center points. Any
suggestions? Am I missing something obvious? See attached view.

I need a cure for imeasles.

..................    
Lawrence

IV series 2010

[#2]

Hello,

There currently is no way to supress the visibility of the sketch point geometry but we are looking into the issue. Thank you!

Ralf Walter (Autodesk)

[#3]

OK. Thanks. I got a lot of work to do then recreating.

regards .............. Spotty Muldoon Esq.



"ralfwalter" wrote in message news:6257767@discussion.autodesk.com...
Hello,

There currently is no way to supress the visibility of the sketch point
geometry but we are looking into the issue. Thank you!

Ralf Walter (Autodesk)

[#4]

Hello,

I got the same issue here, and i wonder if there is already a solution for this problem. (because the thread is from 2009). I'm using inventor 2013.

[#5]

i also get into the same issue

is there something done meanwhile?

[#6]

You could set Tools>Application Options>General tab to a real small value on Annotation Scale to make them less visible, but this will also make sketch dimension annotations very small.

http://forums.autodesk.com/t5/Inventor-IdeaStation/idb-p/v1232

[#7]

Thank you for the input but that´s not what i´m searching for

[#8]

---

michael.marx wrote:

i also get into the same issue

is there something done meanwhile?

---

No. 

[#9]

I just found that by going to properties for the sketch into which you've imported the ACAD drawing, you can change lineweight and all the points become far less prominent.