Autodesk Inventor

[#1]

Why the hole chart has commas instead of decimal points I don't know but does anyone know how to change them? Even my VAR can't figure this out.

[#2]

This might be related to number formating within the Windows O/S for country. Check: Start>Control Panel>Region and Language>Formats>Additional settings>Numbers>Decimal Symbol:

This also where IV picks its date format.

If it works, through a shrimp on the barbi for me

[#3]

Thanks Blair. Have checked that but no go. Regular and ordinate dims are fine, as are hoe notes. It's just the bloody hoe table decimal points. As a matter of interest how is your hole table formatted, commas or decimal point? Regards, Brendan Henderson BLH Drafting Services

[#4]

How about here?

[#5 · Accepted solution]

RBM on the Hole Table, to bring up the Edit Hole Table, at the bottom in the Column Settings, RMB on the XDIM and select Format Column. Over on the Units, in the Decimal Marker dialogue box, select .Period from the pull down menu. I suspect that yours is set to ,Comma.

[#6]

That's the trick blair. Thanks too you and to all who assisted. That's been bugging me for 2 years! Thought I better get it sorted once and for all before we upgrade to 2013 next week!