Bend Table Problem

[Anonymous]

Guys,

Please bend part attached. And original txt file from client

When I make a 90 degree bend on a model with 10mm thickness I get the following when I try to make flat patteren:

Create Flat Pattern (ShapeManager): problems encountered while executing this command.
Part1: Warnings occurred during update
Part1 (Flat Pattern): Warnings occurred during update
Definition1: Problems occurred while building this ASMFlatPattern
Error querying the Bend Table. The angle or radius are outside the table boundaries. The input values were: Thickness: [10,000000], Angle: [90,000000], Inner Radius [10,000000].
Error querying the Bend Table. The angle or radius are outside the table boundaries. The input values were: Thickness: [10,000000], Angle: [90,000000], Inner Radius [10,000000].
Error querying the Bend Table. The angle or radius are outside the table boundaries. The input values were: Thickness: [10,000000], Angle: [90,000000], Inner Radius [10,000000].
Error querying the Bend Table. The angle or radius are outside the table boundaries. The input values were: Thickness: [10,000000], Angle: [90,000000], Inner Radius [10,000000].

I have radius set to 15mm don't I?

What am I doing wrong here?

Thanks

Michael

[jletcher · Accepted solution]

You need to change either the radius in your part or your bend table.

Your bend table has a 15mm radius but your model has a 10mm radius.

This is the issue change one or the otheer and you are good to go..

Or just make another column with a 10mm radius.