Just FYI. I have a very large cooling tower - 7000+ Inventor parts - ~30,000 Intent parts. I'm trying to debug a drawing error. It runs fine to create the model in about 2 hours. Then I add the drawing and get the error. It is kind-of a normal error I think... nothing special. 3 times now, however, I've gotten to that state and then started to debug the error and at a point when I was seemingly doing nothing - looking at the code or the tree - out of the blue Inventor crashed. It has happened on at least 2 different computers.
I know you can't do much to help at this point.
Maybe I should set it up so you can run the code locally. That would be some work, but might be worth it for other reasons too.
Have you submitted any CER reports for these crashes? Could you reply to me with the e-mail address you used so I can find them in the system?
Software Quality Assurance Manager
DLS – Design, Lifecycle, & Simulation