Autodesk Impression
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
Program crash with Impression 2
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
1066 Views, 4 Replies
04-19-2010 04:17 AM
If I want to open each dwg file with impression 2 there every time the program crash. What can be the cause?
Please help me!
Please help me!
Re: Program crash with Impression 2
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
08-11-2010 11:32 AM in reply to:
cadman1966
seems like I remember a problem like this and the reason was not enough memory. Obviosuly if you have more than enoguh then its a differnt reason. If you can try it on another computer that would rule out a bad file. You may try re-installing impressions as well or give version 3 a shot.
Re: Program crash with Impression 2
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
01-26-2011 01:10 PM in reply to:
Jim_Earle
Yikes, crashing on a system with 8gb ram here! Tried it on another with 12gb ram, same result. Trying version 3 now.
Re: Program crash with Impression 2
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
02-03-2011 02:21 PM in reply to:
c.leitch
don't forget to check for service packs
http://usa.autodesk.com/adsk/servlet/ps/dl/index?s
Re: Program crash with Impression 2
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
02-03-2011 02:42 PM in reply to:
cadman1966
Thank you so much, I had not seen the SP. FWIW working fine on version 3.
