Autodesk Impression
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
Impression 3 Printing Problems
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
261 Views, 0 Replies
11-17-2009 06:12 AM
Good Morning,
I recently began using Autodesk Impression 3 and so far have been enjoying it. I have come across one huge flaw, however, which I'm hoping someone will be able to recognize and provide a solution to. Whenever I go to print, I'll set everything up how I need it, hit the print button, and the status bar will come up reading 0%. It sits for a moment before just disappearing; No error message at all. Depending on the machine I'm sending it to in the office it will either print out a blank sheet or just not go through at all. Now I've gotten it to print before on these same machines, but it seems like the first time I print the file it's ok, all the subsequent times is when nothing will go through.
Is this a memory problem? I wouldn't think so for the fact that the print has gone through successfully on two different machines. But any help or suggestions would be greatly appreciated.
Thanks!
I recently began using Autodesk Impression 3 and so far have been enjoying it. I have come across one huge flaw, however, which I'm hoping someone will be able to recognize and provide a solution to. Whenever I go to print, I'll set everything up how I need it, hit the print button, and the status bar will come up reading 0%. It sits for a moment before just disappearing; No error message at all. Depending on the machine I'm sending it to in the office it will either print out a blank sheet or just not go through at all. Now I've gotten it to print before on these same machines, but it seems like the first time I print the file it's ok, all the subsequent times is when nothing will go through.
Is this a memory problem? I wouldn't think so for the fact that the print has gone through successfully on two different machines. But any help or suggestions would be greatly appreciated.
Thanks!
