Autodesk Factory Design Suite General Discussion

Reply
Mentor
j.vanderheijden
Posts: 237
Registered: ‎06-13-2011
Message 1 of 1 (49 Views)

sheet metal style

49 Views, 0 Replies
12-06-2012 11:03 AM

I thought I knew but there is something else.

I have various styles created my behalf sheet metal panels.

Now I want from the base all four sides separate places because we want to be flexible in each side separately adjust the height.

The corners are in a certain way to each other and is dependent on the supplier there for the various styles.

When I made my panel and I change of style I had hoped that the corners would also change, but that does not happen.

If I place the four sides in the same command then the corners change after changing the style.

Now I can do a Corner Seam, but when I change the style, the corners not change.

Am I missing something or is this the manner of Inventor?

 

I attach two parts where the different corners in.

I want to switch between the two styles(corners) in one part.

Mvg Jos

Your drawings are only as good as the symbols that complete them...

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community