sheet metal style

[j.vanderheijden]

I thought I knew but there is something else.

I have various styles created my behalf sheet metal panels.

Now I want from the base all four sides separate places because we want to be flexible in each side separately adjust the height.

The corners are in a certain way to each other and is dependent on the supplier there for the various styles.

When I made my panel and I change of style I had hoped that the corners would also change, but that does not happen.

If I place the four sides in the same command then the corners change after changing the style.

Now I can do a Corner Seam, but when I change the style, the corners not change.

Am I missing something or is this the manner of Inventor?

I attach two parts where the different corners in.

I want to switch between the two styles(corners) in one part.

[S_May]

Hi @j.vanderheijden 

Are you talking about the FDU or is the problem a sheet metal problem?

[S_May · Accepted solution]

Hallo @j.vanderheijden 

the style of the tab can be changed, the style of the corners must be changed separately