Autodesk Architectural Desktop 2007 & Prior
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
AcDbZombie
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
524 Views, 1 Replies
08-22-2006 01:43 PM
Not sure what happened here but when i try to define a block then try to edit it in this dwg i get this response at the command line. i thought it was kind of comical at first but it's getting a little irritating .
has any one encounter this before?
Command: _.refedit Select reference: 5.164279,6372.223729,0.000000
I forgot to add this, it also came in on the command line.
Command: _.refedit Select reference: 3673.953285,6239.697052,0.000000
Errors found in references to other objects:
** Application reference missing: AcDbBlockRepETag, to AcDbPolyline.
Errors found in references to other objects:
** AcDbZombieObject objects cannot be referenced. Message was edited by: chevelle
has any one encounter this before?
Command: _.refedit Select reference: 5.164279,6372.223729,0.000000
I forgot to add this, it also came in on the command line.
Command: _.refedit Select reference: 3673.953285,6239.697052,0.000000
Errors found in references to other objects:
** Application reference missing: AcDbBlockRepETag, to AcDbPolyline.
Errors found in references to other objects:
** AcDbZombieObject objects cannot be referenced. Message was edited by: chevelle
Re: AcDbZombie
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
03-14-2012 10:30 AM in reply to:
75ironhead
I am getting the same error while editing an xref in place.
** Application reference missing: AcDbBlockRepETag, to AcDbPolyline.
As a work around, remove the editted linework from the working set then discard the changes to the xref. Open the xref rather than editting in place and copy paste the revised linework back into the xref. Its a bit of a pain but better than losing your changes. Some feedback from Autodesk would be appreciated as it seems to be a common issue.
