AutoSketch

Reply
New Member
rdfry
Posts: 1
Registered: ‎01-30-2011
Message 1 of 3 (371 Views)

align floor tile starting from a specific point

371 Views, 2 Replies
01-30-2011 01:10 PM

Is it possible to set a specific hatch point  so that I can have a tile on a diagonal start from a specific point .

Mentor
Posts: 150
Registered: ‎02-20-2009
Message 2 of 3 (363 Views)

Re: align floor tile starting from a specific point

01-30-2011 07:47 PM in reply to: rdfry

TOOLS > DRAWING OPTIONS > SCALE > set the drawing origin up, as this is where the hatch is based from (to the best of my knowledge)

Contributor
paul.wacko
Posts: 19
Registered: ‎01-16-2011
Message 3 of 3 (351 Views)

Re: align floor tile starting from a specific point

01-31-2011 04:37 AM in reply to: rdfry

I now would use "Rubber stamp array" and set to rectangle with no gaps.

Paul Jackson
Western Australia
http://www.resolv.com.au

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community