AutoSketch

Reply
Member
JimBenson
Posts: 5
Registered: ‎08-13-2009
Message 1 of 1 (176 Views)

Unable to figure out how to draw exterior walls to start floor plan as I wish

176 Views, 0 Replies
08-30-2011 09:55 AM

I have had Autosketch 10 for quite some time now, and have never been able to use it.

 

The problem stems from not being able to be able to start the floor plans by drawing the perimeter.

 

The perimeters in the wizards do not fit many, perhaps most, of the plans I need to draw; if there is a way to modify those wizards to accommodate say two bay windows, or two corners being cut out for exterior landings or hallways, I have been unable to figure out how from either the Autosketch 9 book that I was sent, or the help in the software itself.

 

I could draw what I needed as a line drawing using relative coordinates, if I could then transform the that line drawing into walls. But when I asked about doing this previously, I was told that it was not an option.

 

Any help would be greatly appreciated.

 

Thank you,

 

Jim Benson

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community