AutoSketch
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
Setting zero on the rulers
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
124 Views, 2 Replies
08-01-2006 02:28 PM
Back in v.2.1 land I could set zero anywhere on the rulers (and work with minus coordinates). I can't see where this is possible on v.9. Also, my snap grids don't line up with the rulers. What am I not seeing?
Re: Setting zero on the rulers
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
08-01-2006 07:37 PM in reply to:
GDKraeger
Sorry for the question about the zero point (origin). I found it in the manual and in the "Help".
Re: Setting zero on the rulers
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
10-24-2011 05:04 AM in reply to:
GDKraeger
Hello,
I finally figured out how to change the grid origin (Cntl Enter), but now how can you set up your rulers to show Grid coordinates instead of Drawing coordinates? I know there must be a simple way to do this, but I just cannot find it. What did you find out?
Thank you.
