AutoSketch
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
SKF Autosketch file conversion
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
236 Views, 1 Replies
01-19-2012 02:47 PM
Greetings,
I have an old copy of Autosketch 6. I cannot install this on any 32bit or higher system, which means I'm screwed. I have a whole bunch of archived drawings from autosketch that are now unreadable.
Autosketch use to have an option to convert to a dxf which was handy to read in autocad but I can't load the old program; therefore, have no way of converting these files.
Is there a way to convert skf files to dxf or dwg?
Re: SKF Autosketch file conversion
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
01-20-2012 09:56 AM in reply to:
joshman
http://www.amazon.com/Autodesk-003A1-051111-1001-A
Please mark any response as "Accept as Solution" if it answers your question.
-----------------------------------------------------------------------------------------------
Dean Saadallah
-----------------------------------------------------------------------------------------------
Dean Saadallah
http://LTisACAD.blogspot.com
RSS: http://ltisacad.blogspot.com/feeds/posts/default
Twitter: http://twitter.com/LTisACAD
Pinterest: http://pinterest.com/pendeaninc/pins/
--
