AutoSketch

Reply
New Member
LineDrawer
Posts: 1
Registered: ‎10-24-2011
Message 1 of 2 (171 Views)

Problems with the Fill Option

171 Views, 1 Replies
10-24-2011 05:08 AM

I am using the Fill Hatch command to fill a circle and changing that into a solid fill using entities.  My problem is that the solid fill is overlapping the line I used to draw the object.  Is there a way to fill the object and have the line on the edge show?  Thanks in advance for any advice.

 

I linked the picture, and it doesn't have a clear line.  If I intensify the line around the fill, you can see the results on the right.  I just want to see a clear border on the object.

Mentor
Posts: 150
Registered: ‎02-20-2009
Message 2 of 2 (154 Views)

Re: Problems with the Fill Option

10-31-2011 02:24 AM in reply to: LineDrawer

There's a toolbar called "arrange", which has a button for "move to front" and "move to back".

 

After a while sketch will begin to forget what's supposed to be where, then you'll need to practice this method:

 

-> Click either the outline object or the fill object to highlight it

-> go to the layers dropdown bar and re-click the layer it's sitting on

-> use the arrange buttons to confirm where this shape should sit

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community