AutoSketch
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
Perpendicu
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
125 Views, 1 Replies
08-17-2009 08:51 AM
In Autosketch 10 the menu shows the possibility to draw a perpendicular line or polyline (NOT the snap mode)
On my PC trying to use this results in an error (my translation, I use the german version) "The chosen objecttype is not valid for this command".
Any ideas anyone?
(Windows XP, all SPs, 2 GB, big harddisk, all other programmes function without problems)
On another PC (same config) this problem does not occur. I have not (consciously) changed any important parameters.
Thanks all for your help Edited by: gedoe on Aug 17, 2009 3:52 PM
On my PC trying to use this results in an error (my translation, I use the german version) "The chosen objecttype is not valid for this command".
Any ideas anyone?
(Windows XP, all SPs, 2 GB, big harddisk, all other programmes function without problems)
On another PC (same config) this problem does not occur. I have not (consciously) changed any important parameters.
Thanks all for your help Edited by: gedoe on Aug 17, 2009 3:52 PM
Re: Perpendicu
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
08-17-2009 05:52 PM in reply to:
gedoe
Hi gedoe
Its the AS program , not your computer or user error. Sorry.
Regards
Jason
Its the AS program , not your computer or user error. Sorry.
Regards
Jason
Regards
Jason
Jason
