AutoSketch
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Line width 1 much to thick on polylines, but ok on simple lines

5 REPLIES 5
Reply
Message 1 of 6
tomte-da
1068 Views, 5 Replies

Line width 1 much to thick on polylines, but ok on simple lines

As you can see in the attached Fig.21.jpg all pliylines are much too thick. Changing them to simple lines would make them as narrow as thow shown.

 

The layers have line width 1 - "Dünnste (1)".

Each polyline has an explicite line width of 1 now, but that does not change anything.

 

I am using Autosketch 7 in Windows XP.

 

Any idea haow to make the polylines as narrow as the simple lines?

 

Thank you in advance!

tomte

Tags (2)
5 REPLIES 5
Message 2 of 6
tomte-da
in reply to: tomte-da

An uggly workaround: Exploding ("Aufloesen") of all polylines. But I can not beleave that this is necessary ... tomte
Message 3 of 6
StevenMac
in reply to: tomte-da

Right click and edit the polyline width until it appears the same as a sketched line?

Message 4 of 6
tomte-da
in reply to: StevenMac

The polyline is already as thin as possible ("1"), there is nothing to change via edit.
Only the _sketched or exploded_ lines having thicknes "1" are really thin.
tomte
Message 5 of 6
StevenMac
in reply to: tomte-da

Polyline thickness goes below 1.
Message 6 of 6
Fred9002
in reply to: tomte-da

I seem to remember that AS7 didn't have real line widths, just device (e.g. printer/monitor) pixel widths which was worthless and confusing.  I'd try avoiding numbers ("1" or whatever) and just set everything to hairline.  

 

 

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report