Active Member
Posts: 6
Registered: ‎06-24-2011
Message 1 of 2 (330 Views)

How to thicken a thin line in both directions?

330 Views, 1 Replies
06-24-2011 03:12 AM



I am looking for an option to thicken a thin line in both directions (from the middle). The result should then be a rectangle with two sides parallel to the initially painted line and two lines that close this parallel lines. In AS 2.1 there was an option "Width" --> from middle --> do not fill (or similar, I only have the german version).


Does this or a similar option exist in AS 10?


Thanks for your support. :smileyhappy:



Posts: 19
Registered: ‎01-16-2011
Message 2 of 2 (311 Views)

Re: How to thicken a thin line in both directions?

07-02-2011 10:09 PM in reply to: siegert.martin

Tht can be done with Polylines from the editbar.


Paul J

Paul Jackson
Western Australia

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community