AutoSketch

Reply
Active Member
Posts: 8
Registered: ‎07-21-2007
Message 1 of 4 (1,420 Views)
Accepted Solution

HELP! circular array

1420 Views, 3 Replies
08-11-2011 01:31 PM

I am trying to create a circular array of 3/8" diameter holes. There are 32 holes in the array arranged on a circle diameter of 20". I KNOW  this can be done but I sure can't figure out how. Can one of you folks help me? I am using Autosketch 9. Thanks for the help!

 

plain ol Bill

Mentor
Posts: 150
Registered: ‎02-20-2009
Message 2 of 4 (1,418 Views)

Re: HELP! circular array

08-11-2011 02:23 PM in reply to: wcottr

I use AS 10.

 

1. Draw a circle of radius 10"

 

2. Draw your first 3/8's hole on that circle.

2a. Press Q to turn on quadrant snap so you can draw the 3/8's at a fixed point (12 o'clock, 3, 6, 9) or

2b. Draw a straight line from the centre of the r10" circle at a specific angle

http://i20.photobucket.com/albums/b238/-Bastard_Child-/c78e44df.jpg

 

3. Select the 3/8's circle to turn on the circular array tool

 

4. Divide 360 degrees by your interval (=11.25 degrees)

 

5. Enter as follows: http://i20.photobucket.com/albums/b238/-Bastard_Child-/6637d388.jpg

5a. If we do 32 copies we'll have two circles on top of each other at the start

5b. If that tick box is ticked it'll dump circles on top of each other

 

6. Press OK and pick the centre of the r10 as your base (keyboard shortcut for centre snap = C)

 

 

 

 

 

 

draw a straight line at a specific angle

Active Member
Posts: 8
Registered: ‎07-21-2007
Message 3 of 4 (1,411 Views)

Re: HELP! circular array

08-12-2011 06:31 PM in reply to: StevenMac

Thanks for the reply - that worked. I had done it before but it had been too long for this old memory to figure out what the heck I had done.

Mentor
Posts: 150
Registered: ‎02-20-2009
Message 4 of 4 (1,406 Views)

Re: HELP! circular array

08-13-2011 06:45 AM in reply to: wcottr

That's ok, if you have any more questions keep them coming.

 

What's really frightening is the amount of stuff you don't realise you've forgotten!

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community